8 - 5
COM1 Tab
Integrated laser scanner default values are 9600 Baud, 8 data bits, 1 stop bit and No parity.
If these values are changed, the default values are restored after a cold boot or reflashing.
Note: COM1 does not support 5V switchable power on Pin 9 for tethered scanners connected to the MX9 I/O port. Tethered
scanners must be connected to a MX9 cradle.
Setting Default
Baud Rate 9600
Data Bits 8
Stop Bits 1
Parity None
To Next Page
Loading...
