14 - 5
Top View
Desktop Mounting Footprint
Bolts, washers, screws, screwdriver or wrench needed when attaching the MX9 desktop cradle to a protected flat surface
are not supplied by Honeywell.
Periodically check the table mounting hardware and re-tighten if necessary. Table mounting hardware can be finger-tight-
ened.
Note: Do not over-tighten the table mounting hardware. If the cradle is cracked, it must be replaced before being placed
into service.
1. Spare Battery Charging Bay Battery Catch
2. Power port
3. Spare Battery Spring
4. Spare Battery Charging Bay
5. Desktop Table Mounting Holes
6. MX9 Docking/Charging Bay
1. Front
2. Table Mounting Hole Guides
3. Back
Not to Scale
To Next Page
Loading...
