Honeywell MX9 - Supported Launch Commands

9 - 5
Commands Supported by Launch
The commands supported by Launch are detailed below. Square brackets indicate that a parameter is optional. Characters
in Italics represent a variable, and not a literal.
Copy
Delete
DelRegData
Copy ElseIfFile IfFile Mkdir
Delete EndIf IfTerm Rmdir
DelRegData EndIfFile Launch SetRegData
DelRegKey EndIfTerm LaunchCmd SetRegKey
ElseIf FCopy Message Shortcut
Description Copies a file but does not overwrite an existing file.
Syntax Copy,source-file,destination-file
Parameters source-file: The file to be copied, including its path.
destination-file: The destination path and filename.
Example copy,\Storage Card\MyData.dat,\Temp\MyData.dat
Notes If the destination file already exists, it is not overwritten, and no error is given.
If the source file is blank, a zero-byte file is created.
Description Deletes the specified file.
Syntax Delete,source-file
Parameter source-file: The file to be deleted, including its path.
Example delete,\Temp\MyData.dat
Description Deletes a specified registry data field.
Syntax Delregdata,key,subkey,field
Parameter key: The abbreviated major registry key where you want to delete a field. Can be one of:
• cr or hkcr (HKEY_CLASSES_ROOT)
• cu or hkcu (HKEY_CURRENT_USER)
• lm or hklm (HKEY_LOCAL_MACHINE).
The case of key does not matter.
subkey: The subkey that holds the field you want to delete.
field: The field that you want to delete.
Example delregdata,LM,Software\WidgetsPlc\OurApp,AppName
Notes An error isn’t displayed if you specify a non-existent field, but is displayed if you specify a
non-existent key or subkey.