Honeywell Notifier ACPS-610/E - 3: in a BB-25 Cabinet; 4: in a BB-100 Cabinet

16 ACPS-610/E Manual — P/N 53018:A1 07/31/2007
Installation Mounting Options
2.1.3 In a BB-25 Cabinet
The ACPS-610 mounts in the left side of a BB-25 cabinet. Two 26 amp-hour batteries fit into the
right side of the cabinet. A BB-100 or BB-200 cabinet is required for batteries larger than 26 amp-
hour.
2.1.4 In a BB-100 Cabinet
The ACPS-610 mounts in a BB-100 cabinet.
Two 55 or 100 amp-hour batteries fit into the
bottom of this cabinet under the ACPS-610.
The power supply is fastened directly to the
unpainted section of the backbox using the
two provided keps nuts.
Figure 2.4 BB-25 Cabinet Mounting
Fasten the power supply to the backbox with two # 8-32 self-threading
screws, included, (P/N 38132) at the indicated positions.
ACPS-610_BB25.cdr
Figure 2.5 BB-100 Mounting
ACPS-610_BB100_2Batt.cdr
Fasten the ACPS-610 chassis to the backbox using the two
# 4-40 keps nuts, included, (P/N 36045) at these positions.
!
WARNING: Heavy Load!
The total weight of a fully loaded BB-100 will exceed 175 pounds. Additional support may be required
when mounting this cabinet to a wall.
See BB-100/200 Cabinet Installation Instructions for more information.