Honeywell Notifier ACPS-610/E - Section 1: Introduction; 1.1 Features

ACPS-610/E Manual — P/N 53018:A1 07/31/2007 7
Section 1: Introduction
The ACPS-610/E is an addressable power supply and battery charger with 24 VDC outputs. It
operates in FlashScan® or CLIP (Classic Interface Protocol) mode, and has built-in strobe
synchronization. Its four outputs may be independently configured to drive Notification Appliance
Circuits (NACs--constant, coded, or synchronized) or to provide auxiliary power (resettable, door
holder, or general purpose).
1.1 Features
• Addressable by any CLIP or FlashScan Fire Alarm Control Panel (FACP)
• Strobe/NAC Synchronization with System Sensor SpectrAlert® or SpectrAlert® Advance
™
Series horns and strobes, or Gentex or Wheelock horns and strobes. (Use only devices from the
same manufacturer in each system).
• NAC synchronization with UZC-256 (Universal Zone Coder)
• Combined output provides up to 6.0 A total (or up to 10.0 A total when charger is disabled).
– Each output, configured as a NAC, provides 1.5 Amps
– Each output, configured as Power, provides 1.5 Amps with charger enabled and 2.5 Amps
with charger disabled.
• Power-limited outputs
• Charges 12 to 200 AH batteries
• Isolated Signaling Line Circuit (SLC) interface
• Brownout detection
• Battery charger supervision
• Battery voltage supervision
• Selectable charger current
• AC loss detection and AC loss delay reporting
• Switch-selectable Ground Fault Detection
Zero (0)
Ω from any output to Earth will cause Ground Fault Detection.
• Occupies between 5 and 14 addresses on an SLC, depending on configuration
• Selectable Canadian Two-stage option/Canadian Trouble reporting
• UL 864 9th edition compliant
• Configure databases, upgrade firmware, and upload/download to the power supply via USB
port –
J3.
Requires PC or laptop with USB port and PK-PPS programming application.
1.2 Specifications
The ACPS-610 is comprised of two boards; the main control unit (the larger rear board), and the
KAPS-24/E power supply (the smaller front board). See Figure 1.1.
1.2.1 KAPS-24/E Power Supply Board
 AC Power - TB1
ACPS-610 – 120 VAC 50/60 Hz input, 5.0 A max.
ACPS-610E – 220 - 240 VAC 50/60 Hz input, 2.5 A max.
Maximum 12 AWG (3.31 mm
2
) with 600 VAC insulation.
 Secondary Power (Battery) Charging Circuit - TB3
Current-limited, sealed lead-acid battery charger which will charge 12 to 200 AH batteries.