Honeywell Notifier ACPS-610/E - Page 18

18 ACPS-610/E Manual — P/N 53018:A1 07/31/2007
Installation UL Power-limited Wiring Requirements
Terminal block and pin connections are illustrated in Figure 1.1.
Figure 2.7 BB-25 Cabinet: Power-limited Wiring Example, with Two Battery Wiring
Figure 2.8 CAB-4 Series Cabinet: Power-limited Wiring Example
TB1: AC Primary
Power Wiring -
Nonpower-limited
and supervised
TB3:
Nonpower-limited
and supervised
SLC and Output Circuit Wiring:
Power-limited, regulated, and filtered. Supervised
except for TB1: UZC+, UZC–.
Outputs 1-4 supervised in NAC configuration only.
ACPS-610_WireBB25.cdr
ACPS-610_WIRECAB3.cdr
AC
Side-View
Power-limited circuit
Power-
limited
circuits
Nonpower-
limited
circuits
TB3:
Nonpower-limited and
supervised
Ground fault detection
and internal charger
disabled. See page 23.
TB1: AC Primary
Power Wiring -
Nonpower-limited
and supervised
SLC and Output
Circuit Wiring:
Power-limited,
regulated, and filtered.
Supervised except for
TB1: UZC+, UZC–.
Outputs 1-4
supervised in NAC
configuration only.
CAB3WiringSide.cdr