OMNI624 Installation and Setup Guide
5–12
COMMAND KEYSTROKES DESCRIPTION
Change pager number # 58 Lets the user modify the current pager phone number.
Note: Once the number is changed, pager reports will go to that number
until the number is changed again using the #58 command.
Display/Toggle Chime #6 The LCD keypad will display current state and provide option to toggle the
current state. The LED pads will simply toggle the chime state and beep
once to indicate the state has changed.
Multi-partition
assignment
#7 [Code] [user
no.] [1, 2, or 4]
(4 = enable
paging)
Allows the assignment of user codes to multiple partitions. User with
authority of 1 or 2 is required to enter this mode. This allows users to be
enabled in both partitions (1 and 2) and also enables the user for paging
(4).
Pager enable #8 Toggle state of pager. Works same as chime. For user open/close only.
User On-line Download #9 Starts remote connect sequence with PC downloader.
Quick commands are valid for 10 seconds of no activity, unless otherwise stated.
CHANGE PARTITION: [#] [0]
[#] [0] [CODE] [0], [1], [2], or [9]
OMNI-KP and OMNI-KP-US keypads display “EC” (enter code) after pressing #0, then display “CP”
(change partition) after entering the user code.
NOTE: #0 is available to authority level 1 and 2 users only.
QUICK ARMING: # 1
If programmed, Quick Arming will be permitted. Quick Arming allows arming the system without
entry of a user code, and reports as user F or 128 if CID reporting is being used. Quick Arming has not
been evaluated by UL.
NOTE: The system must be in Ready mode. A user code is required to disarm the system. Options
include:
[STAY] [#] [1] Quick Arm the System in the STAY mode
[INSTANT] [#] [1] Quick Arm the System in the INSTANT mode
[STAY][INSTANT] [#] [1] Quick Arm the System in the STAY/INSTANT mode
QUICK FORCED ARMING: # 2
If programmed, then Quick Forced Arming will be permitted. Quick Forced Arming allows arming the
system without entry of a user code, and bypasses any bypassable zones that are not ready. It reports
as user F or 127 if CID reporting is being used. Quick Forced Arming has not been evaluated by UL.
NOTE: Bypassed zones will include all of the individual points assigned to the zone. A user code is
required to disarm.
SET TIME: # 3
Pressing [#] [3] sets the time of the system clock. If a user code is required to set the time, then enter:
[#] + [3] + USER NO. + HOUR + MINUTE + MONTH + DAY + YEAR + CRYSTAL ADJUST
(optional) + ADJUST VALUE (optional)
where:
USER NO. = a valid 4-digit user code
HOUR = two-digit hour of day in military time; e.g., 7AM = 07; 3PM = 15
MINUTE = two-digit minutes of hour; e.g., 9 min = 09; 29 min. = 29
To Next Page
Loading...
Need help?
General
