Section 6. System Programming
6–53
Q 25 KEYFOB 1 CONFIGURATION/SERIAL NUMBER
Q 26 KEYFOB 2 CONFIGURATION/SERIAL NUMBER
Q 27 KEYFOB 3 CONFIGURATION/SERIAL NUMBER
Q 28 KEYFOB 4 CONFIGURATION/SERIAL NUMBER
Q 29 KEYFOB 5 CONFIGURATION/SERIAL NUMBER
Q 30 KEYFOB 6 CONFIGURATION/SERIAL NUMBER
Q 31 KEYFOB 7 CONFIGURATION/SERIAL NUMBER
Q 32 KEYFOB 8 CONFIGURATION/SERIAL NUMBER
Programming Submode 4: DESCRIPTOR PROGRAMMING
Press [✱] [BYPASS] while in Installer Mode 1, then press [4] to enter Descriptor Programming
submode.
To create a descriptor:
1. Press [✱] then the Question number representing the zone number desired.
2. Press the INSTANT key to move the cursor to the desired location within that Question.
3. Press one of the character display keys (see table below) to display the character set.
4. When the desired character appears, press INSTANT. The character is accepted and the cursor
moves to the next location. To move to a previous location to change a character, if needed, press
CODE.
5. When the descriptor is complete, accept the entry by pressing [✱] then the next Question number.
Refer to the following chart when entering descriptors:
Key Function
INSTANT Accepts displayed character and moves cursor forward one
position.
CODE Moves cursor backward one position.
[7] Displays next character in character set.
[9] Displays previous character in character set.
[#] [7] Automatically scrolls character set display forward.
[#] [9] Automatically scrolls character set display backward.
[8] Stops auto scrolling.
[0] Inserts a blank character.
QUESTIONS 01–24 ZONE DESCRIPTORS FOR ZONES 01–24
L1
L2
L3
L4
L5 L6 L7 L8 L9 L10 L11 L12 L13
L14
L15
L16
To Next Page
Loading...
Need help?
General
