OMNI624 Installation and Setup Guide
1–2
• Upload/download and remote commands
• 3 methods of uploading/downloading: PC,
operator-initiated, and unattended
• Paging (audio format) capabilities
• Auto-arming at a specific time of day with
capability to arm in either Away, Stay, or
Instant modes
• Dual entry timers
• Fire zone reset through keypad
• Glassbreak reset through keypad
• Bell Test, Low Battery Test, AC loss and
communications failure
• Input power: 16.5VAC, 25VA; 12VDC, 4-7AH
• Output power: 12VDC, 500mA
• Bell output power: 12VDC, 1A
Special Notes
!
IMPORTANT - Failure to install and program this unit in accordance with the UL
requirement is a violation of the listing mark. For more information on UL Listings,
contact Underwriters Laboratories, Progress Department, 333 Pfingsten Road,
Northbrook, IL 60062.
UL Listings
The OMNI624 is the Residential (Household) version of the control panel, and has been Listed by
Underwriters Laboratories for the following applications:
• UL 1023 Household Burglary
• UL 985 Household Fire Warning
FCC Registration Number: 5GBUSA-44003-AL-E
References to Programming Questions
Programming questions are grouped into 4 installer programming submodes, as follows:
1 – System Options
2 – Zone and Report Code Programming
3 – Wireless Zone/Keyfob Programming
4 – Zone Descriptor Programming
Throughout this manual, programming question references without a submode designation pertain to
questions in submode 1 (system options). Programming questions for other submodes include the
appropriate submode number.
To Next Page
Loading...
Need help?
General
