Honeywell OMNI 624 User Manual

OMNI624 Installation and Setup Guide
6–4
ALARM
FIRE
INSTANT
BYPASS
TRBL
PAGE
STAY
SUPRVSN
CANCELED
CHIME
BAT
NOT READY
PHONE
TEST
TAMPER NO AC
21
FIXED
DIGITS
SUBMODE
INDICATORS
QUESTION
NUMBER
INDICATOR
LCD
DISPLAY
OMNI624-008-V0
Submode Indicators = STAY, INSTANT, and BYPASS indicators: The STAY, INSTANT, and
BYPASS indicators provide the current submode number. The current submode number is as follows:
STAY lit, INSTANT and BYPASS off = submode 1
STAY and INSTANT lit, BYPASS off = submode 2
STAY, INSTANT, and BYPASS lit = submode 3
NOTE: Submode 4 cannot be displayed on a fixed-word keypad. Submode 4 contains descriptive
information for display on an LCD keypad. Therefore, programming in submode 4 would be
meaningless on a fixed-word keypad.
Question Numbers = ALARM indicator and LCD display: While ALARM is lit, the LCD digits are
displaying a question number. When a question number is entered on the keypad, ALARM will light
and the LCD digits will display the question number for 2 seconds before automatically changing to a
display of the Location and Location Content. ALARM extinguishes when the display switches to
Location/Location Content.
Location and Location Contents = Fixed Digits and LCD display: The location number will
normally be shown in the first-character position of the 2-character LCD display. However, when the
question contains more than 9 locations, the fixed digits will be used with the first LCD character to
indicate locations 10 through 19 (fixed digit 1 and the LCD character) or 20 through 29 (fixed digit 2
and the LCD character). While the location number is being displayed, the content of the location is
displayed in the second-character position of the 2-character LCD display.
KEY ENTRIES
The below listing provides the function of certain key sequences when a fixed-word keypad is used to
program the system.

Honeywell OMNI 624 Specifications

General

Brand	Honeywell
Model	OMNI 624
Category	Security System
Language	English