www.honeywell.com/security
66 | Performance Series IP Camera Software Configuration Guide
UPnP
UPnP lets you establish the mapping relationship between the LAN and the public network. In
the UPnP configuration interface, you can add, modify, or remove a UPnP item.
Figure 5-16 UPnP Configuration Interface
Enabling UPnP in Windows
When UPnP is enabled in Windows, the camera can be detected automatically through My
Network Places.
Note The UPnP are enabled by default on Windows 7 systems. This procedure applies
to Windows XP.
Interval The interval for sending ranges from 0 to 3600 seconds. 0 seconds
means that there is no interval.
The system will not immediately send the email when the alarm occurs.
When an alarm, motion detection, or abnormality occurs to activate an
email, the system sends the email according to the interval that you
have specified here. This reduces the load on the email server when
numerous emails are triggered simultaneously.
Health Mail Enable Select the check box to enable this function.
Update Period
(interval)
This allows the system to send a test email to check the connection.
Select the check box to enable this function, and then set the
corresponding email interval.
You can set the Update Period so that the system sends out regularly
scheduled emails.
Email Test The system will automatically send an email to test the connection.
Before you can do an email test, you must save the email setup
information.
Table 5-11 SMTP (Email) Configurations (cont’d)
Parameter Function
To Next Page
Loading...
Need help?
General
