Configuring Camera Settings | 67
800-21358 - A - 10/2015
1. Go to Start Control Panel Add or remove programs.
2. Click Add or remove programs, and then select Network Services from the Windows
Components Wizard.
3. Click Details, and then click to select Internet Gateway Device Discovery and Control
client and UPnP User Interface.
4. Click OK to begin the installation.
Bonjour
Bonjour is based on the multicast DNS service from Apple. It can automatically broadcast its
service information and listen to the camera information from the other camera.
Figure 5-17 Bonjour Configuration Interface
If you do not know the network camera’s information, such as its IP address, you can use
Bonjour’s browser in the same LAN to search for and access network cameras. After the
network camera is detected by Bonjour, you can see the server name.
1. Click Display All Bookmarks in your browser.
2. Open Bonjour. The system should automatically detect network cameras through Bonjour
on the LAN.
Multicast
Multicast is a transmission mode for data packets. When there are multiple hosts to receive the
same data packet, multiple cast (multicast) is the best option for reducing the bandwidth and
the CPU load. The source host can send out just one data packet. This function depends on the
relationship between group members and the router’s group.
In the Multicast configuration interface, you can set the multicast address and port.
Note You also need to go to the Live interface to set the protocol to Multicast. See
Protocols in Video Encoder Settings on page 36.
To Next Page
Loading...
Need help?
General
