4 Applicator Interface Kit Installation Guide
14. The flat cable should run as illustrated.
15. Put the cover back on the electronics compartment.
16. Connect the communication cables to the connectors on the printer’s rear
plate.
17. Connect the power cord and switch on the power.
18. In case the interface provides additional serial communication ports, enter
the Setup Mode to set the proper communication parameters for these
ports.
Remarks
• The left-hand slot is the slot closest to the center section.
• Always start by fitting an interface board in the left-hand slot.
CPU Board
Cable
Spacer (existing)
Inner Inte
rface Board
Screw (existing)
Applicator Interface
RS-232/422/485
To Next Page
Loading...
