Honeywell S4565 - SPECIFICATIONS S4565 C, D, R, T; Technical Specifications

EN2R-9031 0402R15-NE 14
SPECIFICATIONS S4565C, D, R, T
Model
Suffix C: fan assisted, direct burner ignition
Suffix D: fan assisted, intermittent pilot burner ignition
including safety timer
Suffix R: as C except volatile lock-out
Suffix T: as D except volatile lock-out
Supply voltage
220 ... 240 Vac, 50/60Hz (-15%, +10%)
Power consumption
4 VA
Humidity
90% RH max. at 40°C
Ambient temperature
-15 ... 60°C
Electrical rating (see also note 7.)
Alarm: 220 ... 240 Vac, 50/60Hz, 1 A,
cos ϕ > 0.6 or max 1 mA
Fan: 220 ... 240 Vac, 50/60Hz, 1 A,
cos ϕ > 0.6
LPG outdoor valve: 220 ... 240 Vac, 50/60Hz, 1 A,
cos ϕ > 0.6
External ignition transformer: 220 ... 240 Vac, 50/60Hz,
1 A, cos ϕ > 0.6
Electrical connection
High voltage spark: 2.8 x 0.5 mm spade terminal
Optional: External mains voltage ignition
transformer
2.8 x 0.5 mm spade terminal
Flame sensing: 4.8 x 0.8 mm spade terminal or 2.8 x
0.5 mm spade terminal for combined
high voltage spark/flame sensing
PCB connectors: Molex 3003 series suitable for
Molex 3001 female cable connector
Housing (degree of protection)
See:
accessories for degree of protection page 7..
replacement parts and accessories page 66..
Timing (depending on O.S. number)
Self check time (T
c
): 0, 1.5 or 2 s
Prepurge time (T
p
): 0 ... 30 s
Safety time (T
s
): 3.5 ...55 s
Extended spark ignition
time and stabilisation time: 0 ... T
s
(depending on elaps of safety time)
Flame sensing
Min flame current: 0.9 µA
Response time on: > 0.2 s
Response time off (T
FR
): < 1 s
(optionally other values available)
Ignition
Spark voltage: > 12 kV at 40 pF load
(depending on O.S. number)
Spark energy: 3 ... 15 µAs
Repetition rate: 2.5 ... 60 Hz
(depending on O.S. number)
Max spark gap: 3.5 mm
Length flame sensing cable
1 m max.
Length ignition cable
0.5 m max.
Length of wiring for external components
1 m max.