Page 32 FOUNDATION Fieldbus ST 700 Pressure Transmitter User's Guide Revision 2.0
Parameter Description
LEVEL_COEFF Indicates the Level Coefficient.
MET_BOD_BCODE The bar code value of the installed meter body.
SENSOR_MAX_OP The maximum over pressure that the device can resist.
SENSOR_MAX_SP The maximum static pressure that the device can resist.
CHAR_DATE Represents the date in which the meter body was characterized.
HARD_REV The Hardware revision of the sensor electronics module.
FIRM_REV The Firmware revision of the sensor electronics module.
CURR_TIME_DATE Represents the date and time of the last performed calibration. This
parameter is to be used in conjunction with the Upload Cal History.
LAST_TIME_DATE Represents the date and time of calibration performed prior to the current
calibration.
PREV_TIME_DATE Represents the date and time of calibration performed prior to the last
calibration.
UPLOAD_CALIB_DATA Selection of appropriate calibration, updates the current, last and previous
calibration dates performed on the device.
Attributes
Supported Modes
The block supports the following modes:
• AUTO (Automatic)
• OOS (Out of Service).
Alarm Types
The block supports standard block alarms (see section 3.2).
To Next Page
Loading...
