TB7100A1000 MULTIPRO™ MULTISPEED AND MULTIPURPOSE THERMOSTAT
62-0273—05 12
NOTE: Press the Done key to exit the Installer System Test.
0700 Temperature
Display Offset
0 -3 (-1.5)— -3°F (-1.5°C)
-2 (-1.0)— -2°F (-1.0°C)
-1 (-0.5)— -1°F (-0.5°C)
0 (0.0)—0°F (0.0°C)
1 (0.5)—1°F (0.5°C)
2 (1.0)— 2°F (1.0°C)
3 (1.5)—3°F (1.5°C)
This offset applies to both the control temperature
and to the display temperature for indoor sensor
(and remote indoor sensor).
0710 Restore Factory
Defaults
0 0—No
1—Yes
Resets all ISU parameters to default values and
resets the schedule to default energy savings (see
Table 5). Retains only calendar settings and time.
0720 Screen Display 2 0—Display Room
Temperature
1—Display Setpoint
2—Display Both
INSTALLER TESTS
Test 1 Installer Test
Cool
00—Off
1—Cool Stage 1
Only shown if system has cool stages.
Test 2 Installer Test
Fan
00—Off
1—Fan Stage 1
2—Fan Stage 2
3—Fan Stage 3
Only shown if system has fan.
Test 3 Installer Test
Heat
00—Off
1—Heat Stage 1
2—Heat Stage 2
Only shown if system has fan.
Systems with 2 Heat stages will have option 2
enabled for Installer Test 3.
Test 4 Installer Test EM
Heat
0 0—EM Heat Off
1—EM Heat On
Only shown if multi-stage HP is selected (heat
pump with more heating than cooling stages).
Table 4. Installer Setup Menu. (Continued)
Installer
Setup
Number
Installer Setup
Name
Default
Setting All Settings Notes
To Next Page
Loading...
