Honeywell TR80UWD - Power Button Functions

TR80 - Installation and Operation Guide 42
3. 8. 6 Power button functions
For the device’s READY mode, the power button can be assigned different functions.
The power button function is described in the below table.
TR80 is primarily a display, not a control device. Therefore, further settings and some con-
figuration on the master controller or DALI side are required for these functions to work.
Relevant TR80 settings:
• Departure delay: This is a parameter on the TR80 with a default of 10 seconds. When the
power-button press is to activate ‘Lights Off’ command, the display will count down
from this value before executing the command. This is to ensure the room tenant is not
left in the dark when exiting.
• Scene settings for lights on & off: If a DALI64 sensor is on port 2, the TR80 can turn the
lights on/off directly without involving the master controller. It will do that by sending
‘recall scene’ commands to the DALI64 sensor. Therefore, it is necessary to set which
scenes numbers are configured on the DALI side to turn the lights fully off or fully on.
These settings are detailed in section 3.11.6.
• If a scene number is not set for Lights On or Lights Off functions, TR80 will send
absolute light level commands (100% / 0%) instead.
Register
type
Relative
Address
Absolute
Address
Dir Name
Config
parameter
Type Range
Default
value
Holding 2110 42111 R/W
Power Button
Short Press
Function
108 enum
0: No function
1: Dark Mode
2: Sleep Mode
3:SwitchLightsOnOff
Toggle
4: SwitchLights On
5: SwitchLights Off
2
Holding 2111 42112 R/W
Power Button
long Press
Function
109 enum Same as above 0
Holding 115 2118 R/W
Departure
delay
42119 secs 0-300 seconds 10 s
Input 102 30103 R
Power Button
user
command
- enum
0: default
1: Lights On
activated
2: Lights Off
activated
Value Function Description
0 No Function The power button will not be enabled
1 Dark Mode The power button activates dark mode.
2 Sleep Mode The power button switches the device to SLEEP mode.
3 Switch Lights On Off Toggle
With each tap, the power button toggleson/off commands to all defined
lighting groups.
4 Switch Lights On
On every tap, the power button sends on command to all defined lighting
groups.
5 Switch Lights Off
On every tap, the power button sends off command to all defined lighting
groups.