53 TR80 - Installation and Operation Guide
3. 11. 5 Light Group 4 configuration & control
The group 3 configuration parameters are explained in below table. Refer lighting group1 for
explanation.
The group 3 control parameters are explained in below table. Refer lighting group1 for
explanation.
3. 11. 6 Scene definitions for Power Button
Wherever the power button function isto turn lights on/off (see register 2110/2111, config
parameter 108/109), the wall module will need to know what scenes to recall for that purpose.
Set to zero if no such scene is configured on the DALI side. If set to zero, TR80 will send abso-
lute light level commands (0% / 100%) to turn lights off / on.
Register
type
Relative
Address
Absolute
Address
Dir Name
Config
Parameter
Unit Range
Default
value
Holding 2314 42315 R/W
Light Group 4
allow dimming
314 enum
0: only on/off
control
1: allow dimming
1
Holding 2315 42316 R/W
Light Group 4
min level
315 % 0…100% 1%
Holding 2316 42317 R/W
Light Group 4
max level
316 % 0…100% 100%
Holding 2317 42318 R/W
Light Group 4
max Scene No
317 int 0-16 4
Register
type
Relative
Address
Absolute
Address
Dir Name Unit Range
Default
value
Holding 1306 41307 R/W Light Group level feedback % 0-100%
32768
(invalid)
Holding 1307 41308 R/W Light Group last scene feedback int 0-15 0
Input 306 30307 R/W Light Group 4 new level % 0-100% 32767
Input 307 30308 R/W Light Group 4 new scene int 0-15 32767
Register
type
Relative
Address
Absolute
Address
Dir Name
Config
parameter
Unit Range
Default
value
Holding 2318 42319 R/W Scene For Lights ON 318 Int -1 - 16 -1
Holding 2319 42320 R/W Scene For Lights OFF 319 Int -1 - 16 -1
To Next Page
Loading...
