7.3.1 Input Range 7-3
7.3.2 Output 1 Action 7-4
7.3.3 Alarm 1 Type 7-4
7.3.4 Alarm 2 Type 7-5
7.3.5 Alarm Inhibit 7-5
7.3.6 Output 2 Usage 7-6
7.3.7 Output 3 Usage 7-7
7.3.8 Communications Link Baud Rate 7-8
7.3.9 Communications Protocol 7-8
7.3.10 Communications Address 7-8
7.3.11 Cold Junction Compensation Enable/Disable 7-8
7.3.12 Lock Code 7-9
7.4 ALARM HYSTERESIS OUTPUTS 7-9
7.5 EXIT FROM CONFIGURATION MODE 7-10
8 INTERNAL LINKS AND SWITCHES 8-1
8.1 REMOVING THE CONTROLLER FROM ITS HOUSING 8-1
8.2 REMOVING/REPLACING THE OUTPUT2/OUTPUT3 OPTION PCBs 8-3
8.3 REMOVING/REPLACING THE RS485 COMMUNICATIONS OPTION
PCB OR DUAL SETPOINT SELECTION INPUT OPTION PCB 8-3
8.4 REPLACING THE CONTROLLER IN ITS HOUSING 8-4
8.5 SELECTION OF INPUT TYPE AND OUTPUT 1 TYPE 8-4
8.5.1 Input Type 8-5
8.5.2 Primary Output (Output 1) Type 8-5
8.6 OUTPUT 2 TYPE/OUTPUT 3 TYPE 8-6
Appendices
A PRODUCT SELECTION GUIDE A-1
B PRODUCT SPECIFICATION B-1
C ADDITIONAL INFORMATION ON TPSC MODELS OF THE UDC1000
CONTROLLER C-1
C.1 PRODUCT SELECTION GUIDE C-1
C.2 PRE-TUNE AND SELF-TUNE FACILITY C-1
C.3 CONNECTIONS AND WIRING C-1
C.4 RELAY OUTPUTS C-2
C.5 SET UP PARAMETERS C-3
C.5.1 Motor Travel Time C-3
(vi)
To Next Page
Loading...
