Honeywell UDC1200 MICRO-PRO - Error Fault Indications

UDC 1200 Start-Up Guide Rev 1
Parameter
Upper
Display
Lower
Display
Description
Instrument
parameters are
in default
conditions


Configuration & Setup required. Seen at
first turn on or if hardware configuration
changed.
Press to enter the Configuration
Mode, next press or to enter the
unlock code number, then press to
proceed.
Over Range

Normal
Input > 5% over-range
Under Range

Normal
Input > 5% under-range
Sensor Break

Normal
Break in input sensor or wiring
Option 1 Error


Option 1 module fault
Option 2 Error

Option 2 module fault
Option 3 Error

Option 3 module fault
Option A Error

Auxiliary Option module fault
10. ERROR/FAULT INDICATIONS