2 - 17
Control Character Output
This selection sends a text string instead of a control character. For example, when the control character for a carriage return is
expected, the output would display [CR] instead of the ASCII code of 0D. Refer to ASCII Conversion Chart (Code Page
1252) on page A-3. Only codes 00 through 1F are converted (the first column of the chart). Default = Off.
Note: Control + ASCII Mode overrides this mode.
Keyboard Modifiers
This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo Mode.
Control + ASCII Mode On: The scanner sends key combinations for ASCII control characters for values 00-1F. Windows is
the preferred mode. All keyboard country codes are supported. DOS mode is a legacy mode, and it does not support all key-
board country codes. New users should use the Windows mode. Refer to Keyboard Function Relationships, page 8-1 for
CTRL+ ASCII Values.
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII control characters for values 00-1F, but it
does not translate any prefix or suffix information.
Default = Control + ASCII Mode Off.
Control Character Output On
* Control Character Output Off
Windows Mode Control + X
Mode On
DOS Mode Control + X Mode On
Windows Mode Prefix/Suffix Off
To Next Page
Loading...
