Voyager 1470/1472 User Guide 29
Control Character Output
This selection sends a text string instead of a control character. For example, when
the control character for a carriage return is expected, the output would display
[CR] instead of the ASCII code of 0D. Refer to ASCII Conversion Chart (Code Page
1252) on page 216. Only codes 00 through 1F are converted (the first column of
the chart). Default = Off.
Note: Control + ASCII Mode overrides this mode.
Keyboard Modifiers
This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo
Mode.
Control + ASCII Mode On: The scanner sends key combinations for ASCII control char-
acters for values 00-1F. Windows is the preferred mode. All keyboard country codes
are supported. DOS mode is a legacy mode, and it does not support all keyboard
country codes. New users should use the Windows mode. Refer to ASCII
Conversion Chart (Code Page 1252), page 216 for CTRL+ ASCII Values.
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII
control characters for values 00-1F, but it does not translate any prefix or suffix
information.
Default = Control + ASCII Mode Off.
Control Character Output On
* Control Character Output Off
Windows Mode Control + X
Mode On
DOS Mode Control + X Mode On
To Next Page
Loading...
