78 Voyager 1470/1472 User Guide
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart, then scanning Save.
Manual Trigger Mode
When in manual trigger mode, the scanner scans until a bar code is read, or until
the trigger is released. Default = Manual Trigger-Normal.
LED Illumination - Manual Trigger
If you wish to set the illumination LED brightness, scan one of the bar codes below.
This sets the LED illumination for the scanner when the trigger is pressed. Default =
High.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the
brighter the LEDs need to be so the scanner can “see” the bar codes
.
User-Specified Good Read Delay
* Manual Trigger - Normal
To Next Page
Loading...
