11 - 10
Medium (2000ms) DLY2RR2000 3-12
Long (3000ms) DLY2RR3000 3-12
Extra Long (4000ms) DLY2RR4000 3-12
Aimer Mode Off SCNAIM0 3-13
*Interlaced SCNAIM2 3-14
Centering Window Centering On DECWIN1 3-14
*Centering Off DECWIN0 3-15
Left of Centering Window (*40%) DECLFT### 3-15
Right of Centering Window (*60%) DECRGT### 3-15
Top of Centering Window (*40%) DECTOP### 3-15
Bottom of Centering Window (*60%) DECBOT### 3-15
Preferred Symbology On PRFENA1 3-15
*Off PRFENA0 3-15
High Priority Symbology PRFCOD## 3-16
Low Priority Symbology PRFBLK## 3-16
Preferred Symbology Timeout
(*500) Range 1-3000
PRFPTO#### 3-16
Preferred Symbology Default PRFDFT 3-16
Output Sequence Editor Enter Sequence SEQBLK 3-18
Default Sequence SEQDFT 3-18
Partial Sequence Transmit Partial Sequence SEQTTS1 3-18
*Discard Partial Sequence SEQTTS0 3-19
Require Output Sequence Required SEQ_EN2 3-19
On/Not Required SEQ_EN1 3-19
*Off SEQ_EN0 3-19
Multiple Symbols On SHOTGN1 3-19
*Off SHOTGN0 3-19
No Read On SHWNRD1 3-19
*Off SHWNRD0 3-20
Video Reverse Video Reverse Only VIDREV1 3-20
Video Reverse and Standard Bar Codes VIDREV2 3-20
*Video Reverse Off VIDREV0 3-20
Working Orientation *Upright ROTATN0 3-21
Vertical, Bottom to Top (Rotate CCW 90°) ROTATN1 3-21
Upside Down ROTATN2 3-21
Vertical, Top to Bottom (Rotate CW 90°) ROTATN3 3-21
Prefix/Suffix Selections
Add CR Suffix to All Symbologies VSUFCR 4-2
Prefix Add Prefix PREBK2## 4-2
Clear One Prefix PRECL2 4-2
Clear All Prefixes PRECA2 4-2
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page
To Next Page
Loading...
