Honeywell Vuquest 3330g - Page 170

11 - 14
Code 11 Default All Code 11
Settings
C11DFT 7-14
*Off C11ENA0 7-14
On C11ENA1 7-14
Code 11 Check Digits Required 1 Check Digit C11CK20 7-14
*2 Check Digits C11CK21 7-14
Code 11 Message Length Minimum (1 - 80) *4 C11MIN## 7-14
Maximum (1 - 80) *80 C11MAX## 7-14
Code 128 Default All Code 128
Settings
128DFT 7-15
Off 128ENA0 7-15
*On 128ENA1 7-15
ISBT Concatenation *Off ISBENA0 7-15
On ISBENA1 7-15
Code 128 Message Length Minimum (0 - 80) *0 128MIN## 7-15
Maximum (0 - 80) *80 128MAX## 7-15
Code 128 Append On 128APP1 7-15
*Off 128APP0 7-16
Code 128 Code Page Code 128 Code Page (*2) 128DCP## 7-16
GS1-128 Default All GS1-128 Settings GS1DFT 7-17
*On GS1ENA1 7-17
Off GS1ENA0 7-17
GS1-128 Message Length Minimum (1 - 80) *1 GS1MIN## 7-17
Maximum (0 - 80) *80 GS1MAX## 7-17
Telepen Default All Telepen
Settings
TELDFT 7-18
*Off TELENA0 7-18
On TELENA1 7-18
Telepen Output *AIM Telepen Output TELOLD0 7-18
Original Telepen Output TELOLD1 7-18
Telepen Message Length Minimum (1 - 60) *1 TELMIN## 7-18
Maximum (1 - 60) *60 TELMAX## 7-18
UPC-A Default All
UPC-A Settings
UPADFT 7-19
Off UPAENA0 7-19
*On UPAENA1 7-19
UPC-A Check Digit Off UPACKX0 7-19
*On UPACKX1 7-19
UPC-A Number System Off UPANSX0 7-19
*On UPANSX1 7-19
UPC-A 2 Digit Addenda *Off UPAAD20 7-20
On UPAAD21 7-20
UPC-A 5 Digit Addenda *Off UPAAD50 7-20
On UPAAD51 7-20
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric entry
Page