Honeywell Xenon 1912 User Manual

13 - 4
Replacing Cables and Batteries
in Cordless Systems
Replacing an Interface Cable in a Base
1. Turn the power to the host system OFF.
2. Disconnect the base’s cable from the terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while maintaining pressure on the connector
release clip.
5. Replace with the new cable.
Insert the connector into the opening and press firmly. The connector
is keyed to go in only one way, and will click into place.
CCB01-010BT Base :
CCB02-100BT Base :

Honeywell Xenon 1912 Specifications

General

Brand	Honeywell
Model	Xenon 1912
Category	Barcode Reader
Language	English