Honeywell XNX-UT Series

XNX Universal Transmitter
HART Protocol
186
Functions in the Congure Menu and the security levels required
to change them are explained in this table.
Symbol Description
Security
Level
Symbol Description
Security
Level
Select Language 1 Calibration Interval 2
Set Date & Time 1
✓
Accept New Sensor
Type
2
Set mV Sensor Type 2 Beam Block Options 2
Set mA Sensor Type 2 Path Length 2
Gas Selection 2 Unit ID 2
Range & Alarms 2 Relay Options 2
Latching/Non-
latching
2 Fieldbus Options 2
Set Units 2 Congure Security 2
mA Levels 2
Functions
Configuration Summary
All of the HART status information can be extracted from the
transmitter as a PDF or text le. This includes voltages, signal
strengths, and conguration settings. An example summary is
shown below.
Figure 239. HART status information