Honeywell XNX User Manual

XNX Universal Transmitter Quick Start Guide
83
Number Description Contents of Data Field
I037 mA for Inhibit Changed f_mA_Flt_Step[0]
I038 mA for Warning Changed f_mA_Flt_Step[1]
I039 mA for Overrange Changed f_mA_Flt_Step[2]
I040 mA for Fault Changed f_mA_Flt_Step[3]
I041 mA for Low Signal Changed f_mA_Flt_Step[4]
I042 mA for Blocked Beam Changed f_mA_Flt_Step[5]
I043 Concentration for mA Full Scale Changed fDisplayRange
I044 Instrument Id Changed N/A
I045 Measuring Units Changed iMeasurementUnits
I046
Alarm 1 Recongured for Increasing
Concentrations
N/A
I047
Alarm 1 Recongured for Depleting
Concentrations
N/A
I048
Alarm 2 Recongured for Increasing
Concentrations
N/A
I049
Alarm 2 Recongured for Depleting
Concentrations
N/A
I050 Alarm 1 Value Changed fAlarmThres[0]
I051 Alarm 2 Value Changed fAlarmThres[1]
I052
Clock Set N/A
I053 Date Format Changed iDateFormat
I054 Sensor Boots N/A
I055 Unused
I056 Sensor RTC Adjusted Error in seconds or +/-999 if large
I057 Fault Set Latching
I058 Fault Set Non-Latching
I059 LCD Heater On
I060 LCD Heater O
I061 Personality Power Up Sensor type
I062 Option Power Up Option type
I063 Loaded Same Cell
I064 Loaded Changed Cell
I065 Loaded Changed Gas
I066 Option Type Changed
I067 HART Address Changed
I068 HART Mode Changed

Honeywell XNX Specifications

General

Brand	Honeywell
Model	XNX
Category	Transmitter
Language	English