4-2. Driving rules
AUTO HOLD
143
AUTO HOLD
In the AUTO HOLD ready state, depress the brake pedal deeply again after the vehicle
is stopped or directly depress the brake pedal deeply until the vehicle stops so as to
the activate AUTO HOLD. At this time, the vehicle will hold the brake when the brake
pedal is released. When the brake pedal or accelerator pedal is depressed with the
gear in D/R, the system will release AUTO HOLD.
When the AUTO HOLD is activated, the
AUTO HOLD indicator lights up on the
instrument cluster.
◼ AUTO HOLD on/off
You can set the on and off of AUTO HOLD function in the vehicle settings of the
multimedia system. (Refer to P.225)
◼ AUTO HOLD function
⚫ AUTO HOLD can also serve as a Hill Hold Control (HHC) function. The Auto Hold
function may not hold the vehicle when it is on a steep slope. In this case, it is
necessary to apply the brakes artificially.
⚫ After the AUTO HOLD is activated for a period of time, the EPB will take over the
AUTO HOLD function.
◼ Working conditions of AUTO HOLD
⚫ The driver side door is closed.
⚫ The driver fastens his seat belt.
⚫ The AUTO HOLD function in the multimedia system is set to on.
⚫ Depress the brake pedal deeply again after the vehicle is stopped; or directly depress
the brake pedal deeply until the vehicle stops and then release the brake pedal.
◼
Parking on slippery roads
If the road holding of the tires is exceeded, the AUTO HOLD function cannot hold the
vehicle. Do not use this system on slippery roads.
◼ When parking
AUTO HOLD function of the vehicle cannot be used for long-term parking. When parking
for long periods of time, please apply the EPB.
To Next Page
Loading...
Need help?
General