Hongqi E-HS9 User Manual

4-3.Operating lights and wipers
150
Washing/wiping operation
Pull back the wiper control handle to
wash the front windshield.
◼ Front windshield wiper and washer working conditions
The power(ignition) switch is in ON mode and the engine hood is closed.
◼ Light and rain sensor
The light and rain sensor determines the
amount of rain.
◼ If the windshield washer fluid cannot be sprayed
Check whether there is washer fluid in the windshield washer fluid tank.
Check and make sure the washer nozzle is not blocked.
◼ If the front windshield wiper blade needs to be replaced
⚫ Set the wiper to the maintenance position in the vehicle settings of the multimedia
system. (Refer to P.223)
⚫ Turn off the power(ignition) switch and switch the wiper control handle to MIST
position within 10s to set the wiper to the maintenance position.
⚫ When the wiper is at the maintenance position, set the power (ignition) switch to ON
mode, operate the wiper control handle to a position other than MIST or turn off the
wiper maintenance position in the vehicle settings of the multimedia system to exit the
maintenance position.

Hongqi E-HS9 Specifications

General

Brand	Hongqi
Model	E-HS9
Category	Automobile
Language	English