CARTONCONTENTS
A. Handle
B. Vacuum Base
C. Air-Powered Hand Tool*
D. Crevice Tool
E. Telescoping Wand
F. Screw (for assembly)
G. Dirt Cup
H Dusting/Upholstery Tool*
*Varies per model
Remove all parts from carton
and identify each item shown.
Make sure all parts are located
before disposing of packing
materials.
Additional parts may be ordered at
Hoover.com or call 1-800-944-9200.
II!
B C E
F
ATTACHHANDLE
Note: Remove the screw located in the vacuum
base and set aside until instruction 1.3
1.2 Insert handle section into vacuum base. Push
down firmly.
1.3 Using a Phillips screwdriver, fasten (1) screw
behind handle into vacuum base.
@
ATTACHDIRT CUP
1.4 Place bottom of dirt cup intovacuum body first.
Pivot cup into vacuum. Dirtcup is secure when you
hear a click.
POSITION TOOLS (varies per model)
1.5 Attach bottom of Air-Powered Hand Too! (A)
and pivot into handle until secure.
1.6 Place Crevice Tool into Wand and slide into
tool storage area on left back side (B) of vacuum
and place Upholstery Tool on right back side (C) of
vacuum as shown.
5 Actual model may vary from images shown.
To Next Page
Loading...
Need help?
General
