EN
Commander mPd 1.4m
6
Battery Selection
We recommend the Spektrum 2200mAh 14.8V 4S 30C Li-Po battery
(SPMX22004S30). Refer to the Optional Parts List for other recommended
batteries. If using a battery other than those listed, the battery should be within the
range of capacity, dimensions and weight of the Spektrum Li-Po battery packs to fit
in the fuselage. Be sure the model balances at the recommended CG.
CAUTION: Always keep hands away from the propeller. When armed, the
motor will turn the propeller in response to any throttle movement.
CAUTION: Always
keep hands away
from the propeller. When
armed, the motor will turn
the propeller in response
to any throttle movement.
C
A
1. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
2. It is recommended to apply hook and loop tape (A) to the bottom of your
battery.
3. Carefully lift the battery hatch (B) to remove.
4. Install the fully charged battery (C) all the way forward in the battery
compartment as shown. Secure using the hook and loop strap (D). See the
Adjusting the Center of Gravity instructions for more information.
5. Make sure the flight battery is secured using the hook and loop straps.
6. Connect the battery to the ESC.
7. Keep the aircraft on its wheels, immobile and away from wind or the system
will not initialize.
Once armed:
• The ESC will sound a series of tones (number of tones will match the battery
cell count).
• The control surfaces will cycle once for AS3X, or twice for SAFE technology if
it is turned ON.
• An LED will light on the receiver.
8. Reinstall the battery hatch.
Battery Installation and ESC Arming
B
D
To Next Page
Loading...
Need help?
General
