To Next Page

To Previous Page

2-12

Installing the Switch

Installation Procedure

Horizontal Surface Mounting

Place the switch on a table or other horizontal surface. The switch comes with

rubber feet in the accessory kit that can be used to help keep the switch from

sliding on the surface.

Attach the rubber feet to the four corners on the bottom of the switch within

the embossed angled lines. Use a sturdy surface in an uncluttered area. You

may want to secure the networking cables and switch power cord to the table

leg or other part of the surface structure to help prevent tripping over the

cords.

Using a Kensington Security Cable

To prevent unauthorized removal of the switch, you can use a Kensington Slim

MicroSaver security cable (not included) to attach the switch to an immovable

object.

Other manuals for HP 1810-8G

Questions and Answers:

Need help?

Do you have a question about the HP 1810-8G and is the answer not in the manual?

General