EasyManua.ls Logo

HP 182C - Specifications

HP 182C
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Model 182C
OPTION
Changes and
Options
Table
7-2.
Model 182C Options (Cont'd)
Factory modification
for
application, with spectrum
analyzer plug-in units. Standard
CRT (VI) is
replaced
by P7
phosphor, CRT, Standard Sweep Gate Output board (A8) is replaced
by
an
Auxiliary
Output board, and the rear panel labeling is changed to identify auxiliary outputs. Make the
following changes
for Option
807: Table 1-1, Specifications,
change
OUTPUTS to:
Four
rear-panel BNC jacks
provide
recorder outputs for use with spectrum analyzer plug ins.
(Refer
to
the plug-in operating
and
service manual
for information about the use of
these
outputs). These outputs should not be used
when
a
standard 1800-series time base plug in
is
installed in the oscilloscope. The calibrated
performance of the time base will be degraded
due to loading.
NOTE
The
signals present at the auxiliary output jacks are directly related to the
plug-in installed. Refer to the plug-in operating and service manual
for
ad-
ditional
information.
Change CATHODE-RAY TUBE to:
Post-accelerator,
22-kV accelerating potential, alumized. P7 phosphor, internal graticule.
Table
6-2
Replaceable Parts. Change Table
6-2
as indicated
for
the listed
components.
Ref. Desig. HP Part No. Description
A3
00182 60019 Assy:
interconnect module
0018261807 Cable assy: auxiliary
A8
00180-66551 Board
assy:
auxiliary
A8C1 0160-3446 C:
fxd
cer220 pF 10% IK Vdc
A8E1
0360-1514
Terminal: pin
A8R1
0757-0438
R: fxd
51 10 ohm 1% 1/8W
0757-0438
R:
fxd
51
10
ohm
1% V8W
0757 0438
R: fxd 5110ohm 1%
1/8W
00182 60024 Panel: reardisplay, top
00182-62701 Filter
assy;
contrast
VI 5083 3932 CRT: P7,
internal
graticule
Note: Delete all other entries beginning with
reference
designation
A8.
Page
8-16,
Figure 8-9,
Replace Figure
8-9 with Figure 7-3.
Page 8-17, Figure 8-10,
Replace Schematic 3
with
Figure
7-4.
Mainframe with blue-gray covers, Make the following changes to Table 6-2, Replaceable parts, for
Option
X95:
MP24: Change
to
HP Part
No. 00182-04102;
COVER:
Top, BLUE-GRAY;
Mfr.
Code 28480;
Mfr.
Part No.
00182-04102.
MP25: Change to HP Part No. 00182-04103; COVER: BOTTOM,
BLUE-GRAY; Mfr. Code
28480;
Mfr. Part No. 00182-04103.
3

Related product manuals