General Information
Model 182C
M7.
WARRANTY
.
M8. This instrument
is
certified and warranted
as stated
on the inside front
cover
of
this manual. The CRT is
covered by a
separate
warranty. The CRT warranty and
warranty claim form are located at the rear of this manual.
Should the CRT fail within the
time
specified
on the
warranty, fill
out the
failure
report form on the reverse side
of the warranty statement and return it with the
CRT. In
all correspondence
with a Hewlett-Packard Sales/Service
Office
concerning an instrument, reference the complete
serial number and
model
of the
instrument,
119. INSTRUMENT IDENTIFICATION.
1-20.
Hewlett-Packard usesa two-section serial number for
instrument identification (Figure 1-2).
The
first
numerical
group Is the
serial
prefix number.
It identifies a series of
instruments. The last numerical group
identifies a partic-
ular instrument
in
the series.
The serial number appears on
a plate located on the rear panel.
SERIAL PREFIX NUMBER SERIAL SUFFIX NUMBER
\
HEVVieTT-PAC'tARD
SERIAL
NO.
oooo a ooooo
I II
COMPLETE
SERIAL
NUMBER
TOOO-A-22
Figure
1-2. Instrument Identification
1-21.
MANUAL IDENTIFICATION
AND
CHANGES.
1-22.
This manual provides
operating and service infor-
mation for the HP Model
182C.
Information
in this
manual
applies
directly
to irtstruments
(as
manufactured)
with a serial prefix
as indicated on the title
page. If the
serial
prefix
of your instrument is different from
that on
the title page, a MANUAL CHANGES insert
sheet, or
Section VII of
this
manual
will describe the changes
necessary
to adapt this manual to provide correct in-
formation,
1-23.
Technical corrections (if any) to this manual due
to known errors
in
print
are called Errata and are shown
on the manual changes sheet. For information on
manual
coverage of any HP
instrument, contact the nearest HP
Sales/Service Office
(addresses are listed
at the rear of
this
manual).
Figure
1-3.
Model 182C Outline Dimensions
1-24.
ACCESSORIES FURNISHED.
1-25.
The Model
182C is
equipped with
a blue
plexiglas
contrast
filter
which provides improved
viewing and
greater
contrast
under
ambient light
conditions.
The filter
slides
into place in the CRT
bezel and may
be removed
if
preferred.
1-26.
A detachable power
cord Is supplied with each
instrument. The three-conductor
power cord and instru-
ment receptacle
conform
to
International
Electrotechnical
Commission
(I EC)
safety
standards.
1-27.
AVAILABLE
ACCESSORIES.
1-28.
A series of mobile test stands
is
available for the
Model
182C. The
Model 1118A
Is a
portable tripod
test-
mobile which provides adjustable height, tilt and rotation,
It is also equipped
with locking wheels and is readily
collapsible
for
transport. The 11 19-serles testmobiles are
general-purpose test stands
designed
for
maximum utility
while requiring
a
minimum of floor
space. These
test-
mobiles
allow the instrument to
be
tilted
at least 40
degrees
above and below horizontal in 10-degree
steps.
1-29.
The Model 101 72A cover, made of flexible material,
covers the entire instrument. The cover
top is slotted
for
access to the carrying handle.
1-2
To Next Page
Loading...
