If the system is ready for the system setup script, the following message appears:
It appears your Cluster is in a proper manual startup state to proceed.
Cluster has the following nodes:
Node 0:
Node 1:
...
Is this correct? Enter < C > to continue or < Q > to quit ==> c
3. Verify the number of controller nodes in the system, then type c and press Enter. If the system
is not ready for the system setup script, an error message appears. After following any
instructions and correcting any problems return to step 2 and attempt to run the setup script
again.
4. Set up the time zone for the operating site:
a. Select a location from the list, type the corresponding number <N>, and press Enter.
b. Select a country, enter the corresponding number <N>, and press ENTER.
c. Select a time zone region, type the corresponding number <N>, and press Enter
d. Verify the time zone settings are correct, type 1 and press Enter.
NOTE: The system automatically makes the time zone change permanent. Disregard
the instructions on the screen for appending the command to make the time zone change
permanent.
5. Press Enter to accept the default time and date, or type the date and time in the format
<MMDDhhmmYYYY>, where MM, DD, hh, mm, and YYYY are the current month, day, hour,
minute, and year, respectively, and then press Enter.
Current date according to the system: <date_and_time>
Enter dates in MMDDhhmmYYYY format. For example, 031822572008 would be March 18,
2012 10:57 PM.
Enter the correct date and time, or just press enter to accept the date shown
above.=> <enter>
(...)
Is this the desired date? (y/n) y
6. To confirm the date setting, type y and press Enter.
7. Name the storage system using up to 31 alphanumeric characters. Type yes and press Enter
to confirm the name.
NOTE: The system name can include only letters, numbers and the special characters “.-_”,
(dot, hyphen, underscore) and can be no more than 31 characters long. The first character
in the sequence must be a letter or number.
Enter the StoreServ system name ==> <systemname>
Cluster will be initialized with the name <systemname>
IS THIS THE CORRECT NAME? yes/change => yes
Cluster is being initialized with the name <systemname> ...Please Wait...
52 Installing Storage Software Manually
To Next Page
Loading...
