3PAR Service Processor Menu
Transfer media: ethernet Transfer status: No transfer yet
Enter Control-C at any time to abort this process
1 ==> SP Control/Status
2 ==> Network Configuration
3 ==> StoreServ Configuration Management
4 ==> StoreServ Product Maintenance
5 ==> Local Notification Configuration
6 ==> Site Authentication Key Manipulation
7 ==> Interactive CLI for a StoreServ
X Exit
3
3. Type 2 and press Enter to Add a new StoreServ.
SP - StoreServ Configuration Manipulation
Enter Control-C at any time to abort this process
1 ==> Display StoreServ information
2 ==> Add a new StoreServ
3 ==> Modify a StoreServ config parameters
4 ==> Remove a StoreServ
X Return to the previous menu
2
4. Enter the IP address of the StoreServ and press Enter.
SP - StoreServ Configuration Manipulation
Enter Control-C at any time to abort this process
Please enter the IP address of the StoreServ you wish to add
-OR -
Enter QUIT to abort:
<static.ip.address>
16:57:36 Reply='<static.ip.address>'
Adding <static.ip.address> to firewall rules on interface eth0
5. Enter a valid user credentials (CLI super-user name and password) to add the HP 3PAR StoreServ
and press Enter.
Please enter valid Customer Credentials (CLI super-user name and password) to add
the HP 3PAR StoreServ.
Username:<Valid Username>
Password:<Valid Password>
56 Installing Storage Software Manually
To Next Page
Loading...
