HP 4262A User Manual

Section V
Paragraphs 5-16 and 5-17
5-16. DUT ADJUSTMENT
RECOMMENDATIONS.
5-17. If HP 16361A/16362A DUT Boxes or sub-
stitute devices are not available, user built DUT’s
with required characteristics may be used to adjust
or to calibrate the 4262A. When it is desired to
adjust the 4262A to perform to its specifications,
the recommended DUT may be selected from
Table 5-3. To establish accuracies appropriate for
comparing the 4262A performance to its specifi-
cations, calibrate the DUT’s to the accuracies given
in the table. Refer to “CALIBRATION OF DUT’s”
(Page 4-4) for proper DUT calibration methods.
Table 5-3. DUT’s Recommended for making Adjustments.
Model 4262A
4 Calibration Required
Paragraph DUT Component HP Part Number Accuracy Characteristics
024 — C: 10n 0160-0408 0.1% D< 0.001
— C: 1000pF 0160-3766 0.1% D<o
< C: 10nF 0160-0408 *D:0.1%
) R: 10kQ 0698-6360 (at 1kHz)
5-25 C: 100pF 0160-0336 *D: 0.1%
R: 100kQ 0698-4158 (at 10kHz)
‘D,tl‘ C: 1000pF 0160-3766 *D: 0.1%
R: 10kQ 0698-6360 (at 10kHz)
C: 10nF 0160-0408 *D: 0.1%
—1HW— R: 3kQ 0698-6348 (at 10kHz)
C: 100nF 0160-4113 *D: 0.1%
R: 1000 0698-6323 (at 10kHz)
C: 100nF 0160-4113 *D: 0.1%
—HW— R: 3000 0698-6346 (at 10kHz)
5-26 C: 18pF 0160-2263 *D: 0.1%
—Hwr R: 8.66kD 0698-3498 (at 10kHz)
* For easier calibration of dissipation to the required accuracy, use accurately
calibrated resistors rather than capacitors (use a high accuracy DMM to
measure resistors).
5-4

HP 4262A Specifications

General

Brand	HP
Model	4262A
Category	Measuring Instruments
Language	English