HP 4262A - Page 77

Section IV Model 4262A
PERFORMANCE TESTS
4-10
3. Confirm that the table on page 4-11 is satisfied when the measurements are made
by changing TEST SIGNAL, CIRCUIT MODE and DUT as given in the table.
Record capacitance and dissipation factor readings in blank spaces provided in
table.
Note
Exror caused by stability of standard com-
ponent is not taken into account for test
limits in the table.
Test limits in parentheses are those for
dissipation factor measurement value.
If tests fail, proceed to Section V ADJUSTMENTS or Section VIII SERVICE.
-