HP 5120 EI Switch Series User Manual

37
To do…
Use the command…
Remarks
Enter ISP domain view
domain isp-name
—
Place the ISP domain to the state of
active or blocked
state { active | block }
Optional
By default, an ISP domain is in the
active state, and users in the domain
can request network services.
Specify the maximum number of
active users in the ISP domain
access-limit enable max-user-
number
Optional
No limit by default
Configure the idle cut function
idle-cut enable minute [ flow ]
Optional
Disabled by default
This command is effective for only
LAN users and portal users.
Configure the self-service server
location function
self-service-url enable url-string
Optional
Disabled by default
Specify the default authorization
user profile
authorization-attribute user-
profile profile-name
Optional
By default, an ISP domain has no
default authorization user profile.
NOTE:
 If a user passes authentication but is authorized with no user profile, the device authorizes the default user profile
of the ISP domain to the user and restricts the user’s behavior based on the profile. For more information about
the user profile, see the chapter “User profile configuration.”
 A self-service RADIUS server, such as Intelligent Management Center (iMC), is required for the self-service server
location function to work. With the self-service function, a user can manage and control his or her accounting
information or card number. A server with self-service software is a self-service server.
Configuring AAA authentication methods for an ISP domain
In AAA, authentication, authorization, and accounting are separate processes. Authentication refers to the
interactive authentication process of username/password/user information during an access or service
request. The authentication process does not send authorization information to a supplicant or trigger
accounting.
AAA supports the following authentication methods:
 No authentication (none)—All users are trusted and no authentication is performed. Generally, do
not use this method.
 Local authentication (local)—Authentication is performed by the NAS, which is configured with the
user information, including the usernames, passwords, and attributes. Local authentication features
high speed and low cost, but the amount of information that can be stored is limited by the
hardware.
 Remote authentication (scheme)—The access device cooperates with a RADIUS or HWTACACS
server to authenticate users. The device can use the standard RADIUS protocol or extended RADIUS
protocol in collaboration with systems like iMC to implement user authentication. Remote
authentication features centralized information management, high capacity, high reliability, and
support for centralized authentication service for multiple access devices. You can configure local or

HP 5120 EI Switch Series Specifications

General

Brand	HP
Model	5120 EI Switch Series
Category	Switch
Language	English