77
Set the port
authorization
state
dot1x port-control { authorized-force |
auto | unauthorized-force } [ interface
interface-list ]
Optional
Use either approach.
By default, auto applies.
In Layer 2
Ethernet
interface view
interface interface-type interface-number
dot1x port-control { authorized-force |
auto | unauthorized-force }
Specifying an access control method
You can specify an access control method for one port in interface view, or for multiple ports in system
view. If different access control methods are specified for a port in system view and interface view, the
one specified later takes effect.
Follow these steps to specify the access control method:
Specify an
access control
method
dot1x port-method { macbased |
portbased } [ interface interface-list ]
Optional
Use either approach.
By default, MAC-based
access control applies.
In Layer 2
Ethernet
interface view
interface interface-type interface-
number
dot1x port-method { macbased |
portbased }
NOTE:
To use both 802.1X and portal authentication on a port, you must specify MAC-based access control.
For more information about portal authentication, see the chapter “Portal configuration.”
Setting the maximum number of concurrent 802.1X users on a
port
You can set the maximum number of concurrent 802.1X users for ports individually in interface view or in
bulk in system view. If different settings are configured for a port in both views, the setting configured later
takes effect.
Follow these steps to set the maximum number of concurrent 802.1X users on a port:
Set the
maximum
number of
concurrent
802.1X users
on a port
dot1x max-user user-number [
interface interface-list ]
Optional
Use either approach.
By default, the maximum number
concurrent 802.1X users is 256.
In Layer 2
Ethernet
interface view
interface interface-type interface-
number
dot1x max-user user-number [
interface interface-list ]
To Next Page
Loading...
Need help?
General