HP 53132A - Preset Values for Functions Accessible Via HP-IB Only

Chapter 2 Operating Your Universal Counter
Preset Values After Power-Up and *RST
Operating Guide 2-91
2
Preset Values for Functions Accessible Via HP-IB Only
Table 2-8. HP 53131A/132A Preset Values—Accessible Via HP-IB Only
Description
In
Save/Recall
Value at *RST
(HP-IB Reset)
Value at
Power-Up
In
Non-Volatile
Memory
Arming Parameters
Frequency ext stop arm slope yes NEG NEG no
Totalize ext stop arm slope yes NEG NEG no
Math, Limit Parameters
Math, limit-test recalculate yes OFF ON no
Reset limit-test fail count on
INITiate yes ON ON no
Statistics Parameters
Statistics type yes MEAN MEAN no
Miscellaneous Measurement
Parameters
Monitor external timebase no TRUE TRUE no
Interpolator calibration on/off no ON ON no
Status Reporting Parameters
Event status enable no ________ 0 no
Service request enable no ________ 0 no
OSR enable no ________ 0 no
OSR negative transition filter no ________ 0 no
OSR positive transition filter no ________ 1809 no
QSR enable no ________ 0 no
QSR positive transition filter no ________ 18277 no
QSR negative transition filter no ________ 0 no
Error queue no ________ cleared no