HP 54600A - Page 25

-
Operating Your Oscilloscope
To use storage oscilloscope operatlo•
3 Using the position knob, move the trace up and down about
one division.
Notice that the last acquired waveform is in full bright and the
previously acquired waveforms are displayed in half bright.
• To characterize the waveforms, use the cursors. See wTo make cursor
measurements" on page
41.
• To clear the display, press 'I -=Er_a_s-e'l.
• To exit the Autostore mode, press either I Run I
or I Autostore 1.
Summary of storage keys
Run -The oscilloscope acquires data and displays the most recent trace.
Stop - The display is frozen.
Autostore - The oscilloscope acquires data, displaying the most recent trace in full
bright and previously acquired waveforms in haH bright.
Erase- Clears the display.
25