-
Operating
Your
Oscilloscope
To
•ake
cursor
•oasuro•o•t•
To
make cursor measurements
The following steps guide you through the front-panel Cursors key.
You
can use the cursors to make custom voltage or time measurements on
the
signal. Examples of custom measurements include rise time
measurements from reference levels other than
10-90%, frequency and
width measurements from levels other than
50%, channel-to-channel
delay measurements, and voltage measurements.
See figures
14
through19 for examples of custom measurements.
1 Connect a signal to
the
oscilloscope and obtain a stable display.
2 Press
I
cursors
j.
A softkey menu appears with six softkey choices. Four of the softkeys
are cursor functions.
source
Selects a channel for the voltage cursor measurements.
Active
cursor
There are four cursor choices:
V1,
and
V2
are voltage
cursors, while
tl,
and t2 are time cursors.
Use
the knob below the
Cursors key to move the cursors. When you press the
Vl and
V2
softkeys simultaneously or the t1 and t2 softkeys simultaneously, the
cursors move together.
Clear
cursors
Erases the cursor readings
and
removes the cursors
from
the
display. ·
41
To Next Page
Loading...
