HP 6125XLG - Configuring IS-IS Network Management

149
Ste
p
Command Remarks
3. Enable IS-IS ISPF.
ispf enable By default, IS-IS is disabled.
Configuring IS-IS network management
This task includes the following configurations:
• Bind an IS-IS process to MIB so that you can use network management software to manage the
specified IS-IS process.
• Enable IS-IS notifications to report important events.
Notifications are delivered to the SNMP module, which outputs the notifications according to the
configured output rules. For more information about SNMP notifications, see Network Management and
Monitoring Configuration Guide.
TRILL uses the IS-IS MIB to provide the TRILL object management function for NMS. Because the MIB
objects defined in the IS-IS MIB are single-instance management objects, NMS cannot manage IS-IS and
TRILL at the same time. According to the management for multiple OSPF instances defined in RFC 4750,
you can set a context name for the SNMP object for managing TRILL. In this way, the SNMP requests for
managing IS-IS and the SNMP requests for managing TRILL from NMS can be distinguished. Because the
context name is a concept specific to SNMPv3, the community names are mapped to context names for
distinguishing different protocols in SNMPv1/v2c.
To configure IS-IS network management:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Bind MIB to an IS-IS
process.
isis mib-binding process-id
By default, MIB is bound to the IS-IS
process with the smallest process
ID.
3. Enable IS-IS
notification sending.
snmp-agent trap enable isis
[ adjacency-state-change | area-mismatch
| authentication | authentication-type |
buffsize-mismatch | id-length-mismatch |
lsdboverload-state-change | lsp-corrupt |
lsp-parse-error | lsp-size-exceeded |
manual-address-drop | max-seq-exceeded
| maxarea-mismatch | own-lsp-purge |
protocol-support | rejected-adjacency |
skip-sequence-number | version-skew ] *
By default, IS-IS notification
sending is enabled.
4. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
5. Configure the context
name for the SNMP
object for managing
IS-IS.
snmp context-name context-name
By default, no context name is set
for the SNMP object for managing
IS-IS.