HP 6125XLG - Ospfv3 Configuration Examples; Ospfv3 Stub Area Configuration Example

370
Pur
p
ose Command
Restart an OSPFv3 process (available in
Release 2406P03 and later versions).
reset ospfv3 [ process-id ] process [ graceful-restart ]
Restart OSPFv3 route redistribution
(available in Release 2406P03 and later
versions).
reset ospfv3 [ process-id ] redistribution
Clear OSPFv3 statistics (available in Release
2406P03 and later versions).
reset ospfv3 [ process-id ] statistics
OSPFv3 configuration examples
OSPFv3 stub area configuration example
Network requirements
As shown in Figure 88:
• Enable OSPFv3 on all switches.
• Split the AS into three areas.
• Configure Switch B and Switch C as ABRs to forward routing information between areas.
• Configure Area 2 as a stub area to reduce LSAs in the area without affecting route reachability.
Figure 88 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic OSPFv3:
# Configure Switch A: enable OSPFv3 and specify the router ID as 1.1.1.1.
<SwitchA> system-view
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 300
[SwitchA-Vlan-interface300] ospfv3 1 area 1
[SwitchA-Vlan-interface300] quit