HP 6125XLG - Configuring a Policy; Creating a Node; Configuring Match Criteria for a Node; Configuring Actions for a Node

316
Configuring a policy
Creating a node
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a node for a policy, and
enter policy node view.
policy-based-route policy-name
[ deny | permit ] node node-number
By default, no policy node is
created.
Configuring match criteria for a node
Ste
p
Command Remarks
1. Enter system
view.
system-view N/A
2. Enter policy
node view.
policy-based-route policy-name [ deny | permit ] node
node-number
N/A
3. Configure an
ACL match
criterion.
if-match acl acl-number{ acl-number | name acl-name }
By default, no ACL
match criterion is
configured.
NOTE:
A
n ACL match criterion uses the specified ACL to match packets regardless of the permit or deny action
and the time range of the ACL. If the specified ACL does not exist, no packet can match the criterion.
Configuring actions for a node
Ste
p
Command Remarks
1. Enter system
view.
system-view N/A
2. Enter policy
node view.
policy-based-route policy-name [ deny |
permit ] node node-number
N/A
3. Set next hops.
apply next-hop [ vpn-instance
vpn-instance-name ] { ip-address [ direct ]
[ track track-entry-number ] }&<1-n>
By default, no next hop is specified.
You can specify multiple next hops for
backup or load sharing by executing
this command once or multiple times.
You can specify a maximum of two
next hops for a node.