409
Tasks at a
lance
(Required.) Configuring IPv6 PBR:
• Configuring IPv6 local PBR
• Configuring IPv6 interface PBR
Configuring an IPv6 policy
Creating an IPv6 node
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Create an IPv6 policy
or policy node, and
enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
By default, no IPv6 policy
node is created.
Configuring match criteria for an IPv6 node
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny | permit ]
node node-number
N/A
3. Configure an ACL
match criterion.
if-match acl { acl6-number | name acl6-name }
By default, no ACL
match criterion is
configured.
NOTE:
n ACL match criterion uses the specified ACL to match packets regardless of the permit or deny action
and the time range of the ACL. If the specified ACL does not exist, no packet can match the criterion.
Configuring actions for an IPv6 node
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny
| permit ] node node-number
N/A
To Next Page
Loading...
