HP 6125XLG - Configuring a RIP Version; Configuring RIP Route Control

26
Ste
p
Command Remarks
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Enable an interface to receive
RIP messages.
rip input
By default, a RIP-enabled interface
can receive RIP messages.
7. Enable an interface to send
RIP messages.
rip output
By default, a RIP-enabled interface
can send RIP messages.
Configuring a RIP version
You can configure a global RIP version in RIP view or an interface-specific RIP version in interface view.
An interface preferentially uses the interface-specific RIP version. If no interface-specific version is
specified, the interface uses the global RIP version. If neither global nor interface-specific RIP version is
configured, the interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts and unicasts, and
RIPv2 broadcasts, multicasts, and unicasts.
To configure a RIP version:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify a global RIP version.
version { 1 | 2 }
By default, no global version is
specified, and an interface sends
RIPv1 broadcasts, and can receive
RIPv1 broadcasts and unicasts,
and RIPv2 broadcasts, multicasts,
and unicasts.
4. Return to system view.
quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Specify a RIP version for the
interface.
rip version { 1 | 2 [ broadcast |
multicast ] }
By default, no interface-specific RIP
version is specified, and the
interface sends RIPv1 broadcasts,
and can receive RIPv1 broadcasts
and unicasts, and RIPv2
broadcasts, multicasts, and
unicasts.
Configuring RIP route control
Before you configure RIP route control, complete the following tasks:
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
• Configure basic RIP.