HP 6125XLG - Ripng Route Redistribution Configuration Examples

344
via FE80::200:2FF:FE64:8904, cost 1, tag 0, AOF, 31 secs
Destination 4::/64,
via FE80::200:2FF:FE64:8904, cost 2, tag 0, AOF, 31 secs
Destination 5::/64,
via FE80::200:2FF:FE64:8904, cost 2, tag 0, AOF, 31 secs
3. Configure route filtering:
# Use IPv6 prefix lists on Switch B to filter received and redistributed routes.
[SwitchB] ipv6 prefix-list aaa permit 4:: 64
[SwitchB] ipv6 prefix-list bbb deny 2:: 64
[SwitchB] ipv6 prefix-list bbb permit :: 0 less-equal 128
[SwitchB] ripng 1
[SwitchB-ripng-1] filter-policy prefix-list aaa export
[SwitchB-ripng-1] filter-policy prefix-list bbb import
[SwitchB-ripng-1] quit
# Display RIPng routing tables on Switch B and Switch A.
[SwitchB] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
----------------------------------------------------------------
Peer FE80::1:100 on Vlan-interface100
Destination 1::/64,
via FE80::2:100, cost 1, tag 0, AOF, 6 secs
Peer FE80::3:200 on Vlan-interface200
Destination 3::/64,
via FE80::2:200, cost 1, tag 0, AOF, 11 secs
Destination 4::/64,
via FE80::2:200, cost 1, tag 0, AOF, 11 secs
Destination 5::/64,
via FE80::2:200, cost 1, tag 0, AOF, 11 secs
[SwitchA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
O - Optimal, F - Flush to RIB
----------------------------------------------------------------
Peer FE80::2:100 on Vlan-interface100
Destination 4::/64,
via FE80::1:100, cost 2, tag 0, AOF, 2 secs
RIPng route redistribution configuration examples
Network requirements
As shown in Figure 86, Switch B communicates with Switch A through RIPng 100 and with Switch C
through RIPng 200.
Configure route redistribution on Switch B, so the two RIPng processes can redistribute routes from each
other.